Source: Customizable Temp Calibration Tower (fixed!) by eibwen
Daily Archives: February 18, 2016
This mod adds a third linear rod in both the Y and Z axes. The third rod greatly reduces the amount of twisting that can occur, especially with an extended Y mod installed. This mod is based off of Jon Lawrence’s 300mm no sag mod. It also includes modifications to [...]
Printrbot Simple 1405 “TRI ROD MOD” with or without XL ...
I was unhappy with the 5/16 threaded rod that the Printrbot comes with and the Z-ribbing artifacts. The problem is the stepper motors have an uneven amount of steps with the 5/16 rod. When you print something with the 5/16 rod, your layer heights will be off every x number [...]