learn raspberry pi at adafruit 3d printing with OctoPrint on the Raspberry pi     30 bucks for a computer.. lots of uses.. Raspberry Pi 2 Model B Project Board – 1GB RAM – 900 MHz Quad-Core CPU: Computers & Accessories Source: Raspberry Pi 2 Model [...]

Raspberry pi I ran across this beginners guide to arduino. Very Very cool. also a good free eBook on PDF that is supposed to be better than the one supplied with starter kits… Source: The Absolute Beginner’s Guide to Arduino IntroArduinoBook Free Software->   Works right out of the [...]

The Absolute Beginner’s Guide to Arduino

No sag/Extended Y-Axis: X Ends: Z Axis: Printrbot Z Axis 5mm threaded rod upgrade by RedJoe I was unhappy with the 5/16 threaded rod that the Printrbot comes with and the Z-ribbing artifacts. The problem is the stepper motors have an uneven amount of steps with the [...]

3D printer upgrades for printrbot 1405 simple makers kit.

Designed for the DJI Phantom 1 This mount allows you to separate your FPV transmitter away from your GPS module minimizing inference. Custom zip tie holes allow you to securely mount your video transmitter or OSD device. (The longer M3*8 extra screws that come with the phantom work well to [...]

DJI Phantom FPV / OSD mount by questpact

A simple and strong FPV LCD holder for the FrSky Taranus or Turnigy 9X. I use it for mounting my RC800, 7″ LCD display. It will also hold other LCDs with back or bottom 1/4-20 mounts. I used a DIY 3S 2000mah battery pack, made of 3 18650 LiPo cells, [...]


I made this for a customer to use his TS58500 mini 5.8GHz FPV video transmitter with his Phantom 2 (with Zenmuse 3D Gimbal). Note: You will need to make a wire to connect the video transmitter correctly (not shown). If you are not expert with these things get help. My [...]

DJI Phantom 2 FPV mount

I’ve had quite a few requests for the motorized version of the hand cranked Perseverance thing ( , so here it is, Perseverance, Motorized. It makes a unique bookend, I receive plenty of inquiries as to where I bought it ( 😉 ). I’ve also printed one using glow in [...]

Perseverance, Motorized by gzumwalt